Connection to Wi-Fi network of JU

Step 1: Activate the wireless network on your laptop

Make sure that the wireless network is enabled. Most laptops have a physical switch or a keyboard shortcut to turn the wireless interface on or off. You can activate this function by pressing the corresponding key or button.

Step 2: Find available Wi-Fi networks

Click the Wi-Fi icon in the bottom right corner of the screen (Windows) or at the top of the screen (macOS). This will display a list of available Wi-Fi networks within range. You should be on the USB campus, where the EDUROAM Wi-Fi network is available.

Step 3: Select a network to connect to

Click on the EDUROAM Wi-Fi network name. Keep in mind that EDUROAM is a secured network, and you will need to enter a username and password.

Step 4: Enter your password

Enter your username in the format: This email address is being protected from spambots. You need JavaScript enabled to view it. and the password you set up in the IDM portal. If you have not set a password yet, go to the section Password settings, freeradius password, and university e-mail, which you can find on this page.

Step 5: Wait for connection

After entering the password, wait until your laptop successfully connects to the network. You can confirm this by checking the Wi-Fi icon, which should indicate that you are connected.

Step 6: Test the connection

To verify that you are successfully connected to the internet, open a web browser and load any webpage.

By following these steps, you should be able to connect your laptop to the Wi-Fi network. Please note that the procedure may vary slightly depending on your operating system and specific device, but in general these steps cover most situations.